Material: Surface abrasive: Aluminum oxide, Base material: PVC, Adhesive: Acrylic synthetic resin
Dimensions: Thickness: 1.4 x Width: 100 x Length: 5000 mm, approx. 0.525 kg (excluding core)
Specifications: Grain size: #36, tape on the back, color: black

It can be used as an anti-slip measure on slippery surfaces such as the beds of carrier cars, loading vehicles, and safety loaders, as well as the steps of trucks, special vehicles, and tanker trucks. It is a tape type, so it is easy to apply.

[Installation precautions]

• 1. Installation in rainy weather will adversely affect adhesion due to the wetness of the installation surface. Take sufficient measures against rainwater infiltration, or postpone installation if this is not possible.
• 2. Please apply the tape when the temperature is 10°C or higher. If the temperature is below 10°C, the adhesive strength of the tape will decrease. If you must apply the tape, use a hair dryer or similar to raise the temperature of the application surface (cargo platform or step side) and the surrounding area.
• 3. Wipe off all dirt, dust and moisture from the application surface. If there is any oil on the surface, clean it thoroughly with detergent.
• 4. To cut the tape, use a cutter to lightly cut the liner paper from the back side, then run the cutter over it 2-3 times to easily cut it. If you cut the corners of the tape round, it will be less likely to peel off after application.
• 5. If you pull the tape too hard when applying it, it will stretch, causing unevenness in the finish and reducing its adhesive strength. Be sure to press the tape down to ensure that the tape's adhesive adheres strongly to the surface. For better adhesion, it is effective to remove any air bubbles and protect the tape with a thick cloth before hitting it with a rubber hammer.
• 6. After application, the adhesive strength of the tape will become stronger over time. If possible, please allow the tape to cure for 3 days after application.
• 7. If you apply the tape by mistake, peel off one end of the tape with a spatula, hold it and slowly pull it in a direction of 90 to 180 degrees to the application surface. Please be careful as it contains artificial abrasives and may cause injury if you touch it directly with bare hands or feet.

◆Please read
⇒About cancellations and returns

Write a review!