Working light switches in the cab for the Isuzu UD JB-5213

商品説明

Dimensions: Width: 23 x Height: 39 mm
Dimensions //
Wiring example //
Specifications//Rating: DC24V-10A, for UD/Isuzu (4t/large) *UD large (from May 2017): Cannot be installed, push switch part/Isuzu small (2007-2022) must be used with height bracket JB-500, Isuzu small/medium (2023-) must be used with height bracket JB-504

*Cannot be installed on large UD vehicles released after May 2017 (vehicles that comply with emission regulations from September 2017 onwards).

To connect, please use two of these harnesses and one relay for each switch.
JB cab switch harness 4 wires JB-503
General purpose relay ACA1223(DC24V)
○Please use this height bracket when installing on the original push switch.
JB Height bracket for cab switch UD/Isuzu (4t/large)
○Please use this height bracket when installing on the original push switch of Isuzu small and medium-sized vehicles (2023 and later).
JB Height bracket for in-cab switches for Isuzu small and medium-sized vehicles (2023 and later) JB-504

[Installation precautions]
● Always use relays for switches inside the cab.
● Make sure there is no coil load (large capacity motor, solenoid, coil, clutch, etc.).
*Please check the [wiring example].

◆Please read
⇒About cancellations and returns