For 4 spacers for switches in JB cab For large Fuso (May 2017-) NE-10AMF4

商品説明

Dimensions: Width: 99.0 x Height: 42.1 mm
Dimensions //
Specifications // For Fuso large vehicles (from May 2017), spacer for removing the glove compartment and installing the JB-52 series cab switch. *When fitting, make sure the protrusion is on the top.

[Product Description]
This spacer is for removing the accessory compartment from the genuine panel of Fuso large vehicles (from May 2017) and installing the JB cab switch JB-52 series . In places where the switch is not needed, please use the dedicated mask NE-10AM to cover the hole.

[Points to note]

* There is a top and bottom direction when fitting. Make sure to install it so that the protrusion in the image is on the top.
*Depending on the vehicle model, there may be some areas where the product cannot be fitted properly. When installing, please check that there is no wobble.

◆Please read
*This product is a special order item.
*This product cannot be returned. Thank you for your understanding. ⇒About cancellations and returns