Material: Iron
Dimensions // Arm length: 180mm
Specifications // For wooden finished tailgate: ELF *Please check [About model selection]

[Product Description]
This Seiko rack was developed for manufacturer-made wooden finished gates. Previously, when installing a Seiko rack on a manufacturer-made wooden finished gate, a base had to be made on the gate side to make the gate surface flat. This product eliminates that hassle and allows it to be directly attached to the gate. There are only a limited number of car models that can be used, so be sure to check the "Model Selection" section below.

[ Comparison of installation image between existing Seiko rack and wooden finished door ]

	→
Installation image of SRC type wooden completed gate		SRN700 Installation image for wooden completed gate

[ About model selection ]

* Click on the image above to check the chassis manufacturer and compatible vehicle model. When checking the vehicle model, please refer to the dimensions (A, J, L, M, E, H) and the shape of the side panels in the image to narrow down the vehicle model.
Once you have confirmed the vehicle model, please select the corresponding model from the product assembly part number. There are two models as follows.
■ Product assembly part number: SRN7-1200N0-36
■ Product assembly part number: SRN7-1180N0-36
This is the PDF of the manufacturer's "Model Selection" and "Installation Instructions". ⇒ Seiko Rack SRN700 Model Selection and Installation Instructions for Wooden Finished Tilt

[Notes]
* Only compatible springs are SRN720 and SRN710. (SRN750 cannot be used.)

◆Please read
*This product is a special order item.
*This product cannot be returned. Thank you for your understanding. ⇒About cancellations and returns

Write a review!