JB cab switch switch tailgate JB-6512 For Fuso large size (from May 2017)
Dimensions // width: 21.7 x longitudinal: 41.4 mm
Wiring example //
Specifications / / Switch type: Seesaw switch, Switch classification: ON-OFF, Rating: DC24V-10A, display: tailgate-OFF, built-in LED, for Fuso Large (from May 2017)
【Description of item】
〇 This is a type of switch that is used by being fitted in the switch mounting hole of the driver's seat dashboard etc.
○ Since it is built in LED, it will illuminate by small interlocking or ON / OFF interlocking depending on wiring specification.
〇 JB Cab Inside Switch When using the Fuso Large (from May 2017) , be sure to use only the JB-65 Fuso Large (from May 2017) harness for switch inside the JB cab . When using the four harness harness JB-503 in the JB cab, the harness will come off as the coupler is not locked.
〇 JB harness switch in JB cab JB - 65 Fuso Large (from May 2017) dedicated we are adopting crimp terminal with lock. When installing on the switch, please push firmly until locked. Once attached to the switch, the crimp terminal can not be pulled out. If you forcibly remove it, there is a danger of breakage, so please be careful when working.
* Switch in the JB Cab For connection for the Fuso Large (from May 2017), there is one stitch "1 for JB-65 Fuso Large (for 2017 May -) Harness Switch for JB Cab Switch " Please use one relay " General purpose relay ACA - 1223 CA1a (DC 24 V) " for 24 VDC , harness "relay harness 4 JB - 503 in the JB cab for harness" for relay.
【Precautions for installation】
● Always use relays for switches in the cab.
● Coil load (motor with large capacity, solenoid, coil, clutch etc) should not be hooked.
※ Please check 【Wiring example】.
◆ Please be sure to read
※ This product is an item to be ordered.
※ This product is not allowed to return. please note that. ⇒ Cancellation and Returns
No review on this item...
Tell your friend about this product. Fill the form below and click the 'Send' button.